VooPoo ITO Replacement Coils

VooPoo ITO Coils

Four mesh resistances from 0.5 to 1.2 ohm make the VooPoo ITO coils the go-to replacements for the Doric 20, Drag Q, Doric Q, Doric SE, and Argus P1. The range covers everything from a loose RDL draw at 25W down to a tight MTL pull at 8W, so you can match the coil to how you vape. Sold in a 5 pack with press-fit installation into ITO and ITO-X pods.

The lower resistances at 0.5 and 0.7 ohm handle 50/50 e-liquids and moderate VG blends up to 70/30, while the 1.0 and 1.2 ohm coils work best with nic salt e-liquids at 10 to 20mg. VG ratios above 70% won't wick properly at these lower wattages.

Key Features

• Four mesh resistances at 0.5, 0.7, 1.0, and 1.2 ohm
• Fits Doric 20, Drag Q, Doric Q, Doric SE, and Argus P1
• 0.5 ohm (ITO M0) at 18 to 25W for the loosest RDL draw 
• 0.7 ohm (ITO M1) at 14 to 18W for a balanced MTL/RDL 
• 1.0 ohm (ITO M2) at 10 to 14W for a tight MTL pull 
• 1.2 ohm (ITO M3) at 8 to 12W for the tightest draw 
• 5 pack with press-fit installation

Resistance Options

The M0 at 0.5 ohm gives the most vapour and suits a lower-strength freebase at 3 to 6mg or 10mg nic salts. The M1 at 0.7 ohm bridges MTL and RDL depending on where you set the wattage. The M2 and M3 are both tight MTL coils built for higher-strength nic salts, with the M3 pulling the draw even tighter and stretching battery life further on smaller kits like the Doric 20.

Which VooPoo Kits These Coils Fit

VooPoo ITO coils press-fit into any VooPoo kit that uses ITO or ITO-X pod cartridges:

• VooPoo Doric 20
• VooPoo Doric Q
• VooPoo Doric SE
• VooPoo Drag Q
• VooPoo Argus P1
• VooPoo Argus Pod (with ITO pods)

These coils will not work with PnP X, PnP-X, TPP, or Argus pod system coils. If your VooPoo kit uses a different pod type, check the VooPoo Coil collection for the right coils.

VooPoo ITO Coil Specifications

What's in the Box

• 5 x VooPoo ITO replacement coils (choose: 0.5, 0.7, 1.0, or 1.2 ohm)